Klipper on Creality

I created this section, as with all the others, to be mindful of the firmware and the mainboard you are flashing. Due to production limitations components may change over time and it’s imperative you make sure you are updating your mainboard with the correct firmware. This effect can be seen with the Ender 3 series of printers. When Creality upgraded the mainboards to the 4.2.2 version it was originally shipped with an STM32 mainboard chip. However, sometime in 2022, the mainboard chip changed to a G32(gigadevice). There is no way of knowing which you have until you open up the electronics case and look at the physical chip within the mainboard. Both mainboards require different version of the Klipper firmware so please be diligent.

**As with most things you find on the internet, especially for free, download and install any or all of these files and profiles at your own risk. Due your diligence and make sure the steps you are taking are all correct for your machine. PrintsLeo3D takes no responsibility for any harm this may cause you or your 3d printer, please proceed with caution!**